|
N.E. OHIO | he brought it back today and said when the chisel was lowered it leveled and worked perfect. after unhooking the chisel we were looking at the 3 point hitch, he lowered it and the arms went down level till they touched the ground. never saw one that went that low. he raised it while i watched it and both arms went up the same until the cylinders were up by the top and then the left cylinder stopped and the right one went up like 5-6 inches, which would explain why the chisel was all whoperjawed, but what would cause this
Profile Private message E-mail Homepage Top of the page Bottom of the page
j.d. 6400 3 pt. ? - corn48 : 10/5/2021 16:20
RE: j.d. 6400 3 pt. ? - MiradaAcres : 10/5/2021 16:29
RE: j.d. 6400 3 pt. ? - corn48 : 10/5/2021 16:43
RE: j.d. 6400 3 pt. ? - MiradaAcres : 10/5/2021 17:05
RE: j.d. 6400 3 pt. ? - WildBuckwheat : 10/5/2021 17:07
RE: j.d. 6400 3 pt. ? - corn48 : 10/5/2021 18:24
RE: j.d. 6400 3 pt. ? - WildBuckwheat : 10/5/2021 19:52
RE: j.d. 6400 3 pt. ? - Olddeeres4ever : 10/5/2021 21:12
RE: j.d. 6400 3 pt. ? - corn48 : 10/6/2021 17:27
| |
|
j.d. 6400 3 pt. ? revisited
