|
Southern Illinois | Need to move a Hutchinson 13” x 102’ Auger a few miles and want to get it as low as possible. Is there any reason I can move this stop all the way back to lower the Auger as much as possible? This auger has the super structure on top so I think there is sufficient strength and it has a hydraulic winch not a cylinder to raise and lower. Planning on using a 3 Pt on an 8420 raise the front higher and get the back lower but looking at all options.
 (B412BD98-7B8C-4244-924D-2ACCA38E2D23 (full).jpeg)
 (6B06E175-C445-4E73-8493-2267C9523C85 (full).jpeg)
Attachments
----------------
 B412BD98-7B8C-4244-924D-2ACCA38E2D23 (full).jpeg (72KB - 33 downloads)
6B06E175-C445-4E73-8493-2267C9523C85 (full).jpeg (112KB - 62 downloads)
| |
|
Any reason I can’t move this stop on a Hutchinson 13” 102’ Auger
