|
West-central Illinois | I have a 16 row 1200 that we are setting up to apply 28% through a yetter coulter/knive setup. This planter was euqipped from the factory for liquid, but for placing it in the row, not to the side of the row. Our dealer installed the fertilizer "bar" underneath the frame of the planter along with the coulters. We are doing the plumbing ourselves. We found two 1" lines that supply the left and right 3 coulters that had been plumbed from the factory through that mess of a pivot system down under the frame where we need them. My question is this: how do I split each of those lines into 3? I have looked at Dultmeier's site and only find 18 hole manifolds, and really don't want to have to buy two of them. Are there any 4 hole splitters? I'm sure there is an easy answer; I just can't see it. TIA | |
|