|
North Carolina | Got my rasp bars put in and thought I would check and see if my
concave was set right. So I opened the inspection holes and tightened the concave all the way up. The hole on the front right hand side, was 3/16ths gap.
Front left side was a roughly 5/16ths. And the back two were 1/8th. So I started to adjust the front left and as I did so the front right got even tighter.
So I worked on it roughly an hour to an hour and a half, and think I got it squared away. Both fronts are a little less than 3/16ths and the back is a little less than 1/8th of an inch. This is with the indicator set at zero.
Are these the right settings or do I need to change something?
Thanks. | |
|
Leveling the concave on a 9500
