|
Crawfordsville, Arkansas | Maybe I'm overthinking this but how should I wire in a voltage gauge to something with a push button start? Got a old piece of equipment that's 24 volt. Simply push the button and it starts. Has mechanical gauges for oil and water temp but I'm needing a voltage gauge also. If I wire it up the way the diagram shows it'll show voltage 24/7 and I'd assume that would run the batteries down over time. This doesn't get much use on a weekly basis to charge the batteries back up.
I want to stick with the push button start switch. Wiring is sparse on this thing so keeping it simple is number one.
Edited by Detroit 5/12/2016 10:35
 (image.jpeg)
 (image.jpeg)
 (image.jpeg)
Attachments
----------------
 image.jpeg (102KB - 80 downloads)
image.jpeg (121KB - 68 downloads)
image.jpeg (98KB - 79 downloads)
| |
|
How to wire in a volt gauge to something with a push button start?
