|
North Carolina | Have had repeated failure of all 24 seed tube sensors today. I have PP SeedSense 20/20 installed and thought the Smart Connector (SC) might have been the problem (it alerted me to a possible planter wiring harness short circuit) but even bypassing all that stuff and the RUM's, my GS2 display still shows all 24 sensors unreponsive. I did check and I have voltage running to them and there are no visible cuts, pinches, abrasion, etc. in the planter harness. So I put the SC in a different location (before the wedegbox) and plugged and unplugged it several times. Each time I got a handful of sensors "operational" but they were different ones each time and when I did a test pass in the driveway, none of them registered seed, altough I was putting seed down. A call to PP and my Deere dealer haven't yet solved the issue. Could my planter wedgebox be bad?? Running SeedStar II on a 2600 display. I really hated to lose a day of planting due to electrical junk!! Would really appreciate some knowledgeable advice here. Thanks!
Edited by Matthew2158 4/2/2012 20:35
| |
|