|
DE | ball joints are loose about 1/4" or better thread showing and are pitted bad as seen in pictures. I tried to tighten with 3/4 imact but no luck, they are seized. This is first valley for me and I can't get over how there isn't any retainer on the ball and socket joint, it just "sits" in there. I brushed on some cold galvanizing compound.
Edited by cowhater 3/29/2012 11:33
 (valley pivot 012 (Small).jpg)
 (valley pivot 013 (Small).jpg)
Attachments
----------------
 valley pivot 012 (Small).jpg (25KB - 38 downloads)
valley pivot 013 (Small).jpg (21KB - 33 downloads)
| |
|
do these valley ball joints need replaced or tightened up?
