|
nc ks | My tech updated my display this winter on my 4930 and put a new card in. I wanted my field boundries and info on the new card. I copied the RCD folder from the old card to the new card. While copying, it would ask me if I wanted to replace a file with another one several times. I always chose the file that was the largest which in a few cases was the file on the new card. WHen I got done and put the new card in the 2600, it still didn't have my field names in it. Should I have ignored any of the new files on the new card and copied all the old files? I was just worried that the new file if larger than the old was updated and needed to stay.
Another question. When my tech updated my display, were all the updates done to the display firmware or are there things on the card that are updated also. | |
|