I bought a case 5500 drill far enough away I’d like to drag it home behind a semi. Semi has a pintle hitch and I bought a pintle hitch ring to put in the drills tongue. The pintle hitches holes and bolts are smaller than the holes on the tongue so only 2 of the holes line up. My question is will the longer thinner bolts be strong enough to hold the hitch if I add some spacers or should I make a plate that is bolted into the other bolt holes then run the 2 pins through the pintle eye? Hope this makes sense. Any other ideas appreciated. This is on a friends drill just down the road. Want to be prepared before driving 3 hrs away