Near Intersection of I-35 & I-90 Southern Mn. | I have an AWS wind bar on a Deere 630F head for soybeans. We had to remove one of the saddles and tubes since it had been rubbing and was close to wearing through. This was on the far end and we noticed a fair amount of debris in the main tube. My great-nephew removed the plug on the end and I started it up. Much dust came out. He poked into the tube and dislodged quite a bit more debris. We did this for a while until nothing more came out.
I don't know if this was all that necessary but it seemed like a good idea and wasn't that hard to do. I now need to adjust the actuator bracket so I can't tip it in quite as far. There are three places where the tubes align with the reel pivots and were causing wear because I had the bar tipped back a bit too far.
Edited by tedbear 9/5/2019 15:56
|
Might want to blow out air tube on air bar for bean head
