|
Iowa | I am wanting to log actual planting with an old grain drill without any electronics on it without having to flip switch or touch the screen everytime i lift the drill and put it down.
I thought I had this all figured out by reading other threads on here but I'm missing something somewhere in the setup .
I had my implement guy build me a plug with wires on pin 10 and 11 and hooked to a whisker switch on a mognet I got from AGExpress.
Then I Tried to get it configured inside my FMX ( FM-1000 ) but not having any luck.
I've got the latest 7.2 firmware installed
Checking manual is says to go to the implement and then the EXTRAS tab and configure for Port A or B and tell it logging high or low - I don't have an EXTRAS Tab and cant figure out where to configure and setup this switch to make it work
Any one have any ideas ?? | |
|
Trimble FMX (FM1000) Implement Switch Installation
