|
| Hell o , new to me i have a hardie 1200 i trying to get started. It has a MT -9000 SRPAY RATE CONTROLLER .Trouble is i have no pressure reading on the moniter. The two pressure gauges are reading 20-30 psi ,booms seem to squirt flow ,shut off works , flow controler seems to spin.
Check the wires for the pressure transducer. seem fine. Followed the book( recieved with the sprayer) that instructed on how to do the pressure offset procedure. Didn't help. I HOPE its a small procedure that i'm missing and not a transducer failure . The controller has been program by the previous owner for three different flow setting and ( limited time i ran it ) it seem to change.
Local dealer was trying to sell one but i purchase this on a online auction and would like to figure this one out ,Dealer is helpfull but they know where i purchase it. Any help would be appriciated.
Thank you for response
Gettin BY | |
|
Hardie 1200
