|
South Australia | I have all my fields set up with the headland mode and saved in my trimble 750, most of my operations are done on multiples of 30' so all works well.
My combine is 36' and the headlands steer no worries, when I come to do the infill AB runs I can't seem to shift the AB line to where I want. The ''shift to here'' icon is unavailable. I tried to nudge it over 210cm which was fine to start with but when I turn at the end to come back the nudge is the wrong way.
I thought my ez 500 could shift to here but I can't remember. I have checked my nudge settings.
Its frustrating doing my first AB run with 8' of empty header hanging out.
Was this a shoftware oversight or what?
Thanks Russell | |
|