|
East Central Ia | I see this topic has been covered quit a bit when I did a search... I just wanted someone to clarify what part numbers I need.
I have an MX 305 with factory Accuguide, using a Case branded 252 on Omnistar.
I need to get GPS from this setup into a JD 2600.
I think I have the correct Trimble cable to plug into port "C" I think... behind the seat by the Nav II controller. It has a 12 pin Duetsch connector, a 12v lighter plug (which I was told won't be needed for power) and a 9 pin serial.
I can get the part number later on that cable.
What cable do I need to go from that to the JD cable. I see the JD cable has a 9 pin serial connector... I assume thats where I need to get the GPS signal too?
And then I need to configure the NAV II to output the signal correctly... 6 decimal places instead of 8? What messages does it need?
Thanks! | |
|
252 GPS into 2600 Part number needed...
