|
| I had what I think is the implement harness (goes to the flow meter, valve, shutoffs - hagie sprayer) pinched under the seat frame. It just flattened the wires, but I think it broke through the insulation a little on the blue wire. I was trying to get the flow valve to open when I found this. While the harness was pinched I had several pop up warnings, but I didn't write down what they were (doh!). Anyway, after freeing the harness I was able to manually adjust the flow valve, but I noticed no gallons counted and on the system tab the counter is at zero. I tried setting the valve calibration to 1 pulse/unit, disconnected the flowmeter cable and used a paper clip to momemtarily short across the 2 and 6 oclock pins (notch at the 12). No nothing.
I tried reloading the firmware (v.7) and reconnecting the modules (aux/liq) and the console with no change. The wires to the flowmeter were not pinched btw. Also, I do have the blue indicators coming on like they should with the foot switch.
Any thoughts? Did I toast a module (or two)? the led's all show green.
thanks lots in advance,
Pat
| |
|
Insight - no flow meter pulses, harness was pinched but...
