|
| Hi all,
I am re-engineering a bale stacker that will hitch to a truck receiver or tractor drawbar, with the load being transfered to a set of rear, trailed tires. I have seen a number of axle and hub orientations on trailed implements and am trying to determine how to best attached the rear wheels.
I have rarely seen a trailed implement wheels, have square angles.... what is the engineering advantage to that?
Here are a few pictures for you to ponder on.
Thanks in advance.
Edited by BondoBuilder 10/24/2026 13:00
 (Seed Drill (full).jpg)
 (Trailed Implement Hub (full).jpg)
Attachments
----------------
 Seed Drill (full).jpg (72KB - 4 downloads)
Trailed Implement Hub (full).jpg (31KB - 6 downloads)
| |
|
Trailed Implement Hub Engineering and Placement
