Southern PA | jpg4320 - 8/20/2026 14:51
I have been reading on the internet. Looks like the header control board. Which one is that? Also, does something need reprogramed after a new one is installed!?
If you check out all the cheap stuff, and you're relatively sure it's a controller, try one off a comparable machine before you buy. That's if you have a buddy with a similiar vintage machine.
If not, check for one at a salvage yard. A new one will need programming, a used one will work with no programming needed.
That is if the used one is any good, LOL.
We replaced two bad controllers on ours over a couple year span with used ones, worked perfect. New was usually around $12 to $1500, plus programming. Used was about 1/3 that price, no programming needed. |
9660 feeder house will not raise
