|
NW Iowa | The cycle unlocks the electrics back to lift. Just hitting lower will not do it. Needs a full cycle.
If no code flashing, other than the buttons you unhooked.
I'd go back and see if the lower solenoid is getting power on
your hyd lift block.
You can bypass them also by pushing on the center button.
Could be a sticky valve, bad switch, or the calculator.
Switch is usually the higher replace vs others.
Make sure your mixer is set correctly.
I'm assuming your position switch is reading correctly
in the C1000.
Edit- Since i don't use the draft.
I'll set the switch in lower and use the knob on the armrest to set my position.
Over on the calculator.
I set my speed where i want it fast or slow. I run on the faster side.
Set my raise knob Hight up
Set my mixer to full position.
Edited by Massey1155 3/28/2026 08:50
| |
|
MF 8650 3 point trouble
