|
SE Nebraska | I have a liquid strip till bar that I used last year. It worked fine last year but in the past I had a different RCM on it. I also had an anhydrous bar with a montag dry box on it and I swapped the other RCM between the strip till bar and the anhydrous bar. I ended up selling the anhydrous bar and the RCM went with it. I bought a new RCM and thought I had it set up correctly but I can’t get it to apply over 6 gpa at a target of 25 gpa. It has a raven flow meter with a tag that says meter cal 710 gal. In the UT I put 710 and changed it from /10gal to /gal. If you change it from /10 gal to /gal I can only get 1 gpa. It has a standard control valve so under control valve setup I selected standard. On the control valve it says valve cal 2123. I don’t see anywhere in the UT to enter a valve cal. I thought maybe the control valve was bad so I changed it to a new one but no luck. When I changed the control valve I blew into the flow meter and it spun freely. I didn’t use compressed air. I am just stumped as what the issue is. Any help is appreciated. Thanks
Edited to add. I am running 70 psi after all the section valves so it’s not a pump issue. Also controlling with a pro 700+ monitor.
Edited by duishay 3/18/2026 21:16
| |
|
Raven Rcm setup problems
