Installing Exapta seed tube guards.
I have Rebounders already installed.
The zip tie to hold the Rebounder runs right through the area where the Seed tube holder is on the Exapta.
I have a few choices here.
A) Remove the Rebounders. I kinda like the Rebounders.
B) Remove the bolt on Seed tube guard guides. This might make the most sense.
C) Move the zip tie up a little bit. I am thinking the zip tie won’t stay in place if I actually do this.
D) Switch to the Keeton Seed Firmers.
E) Run a zip tie through the hole in the Exapta and around the seed tube and the Schaffert Rebounder.
F) Cut the seed tube guides in half. I think that I can make this work.

(IMG_9722 (full).jpeg)

(IMG_9724 (full).jpeg)

IMG_9722 (full).jpeg (151KB - 8 downloads)

IMG_9724 (full).jpeg (118KB - 6 downloads)