Tipton, KS | c_mayer - 3/17/2026 14:31
I have seen plenty of instances on Deere displays, and a few on CNH displays where an ACTUAL ISO 11783 compliant implement would not work on their displays, usually due to software mismatches.....I always say 2016 for CNH, and usually 2017-2018 to be 100% sure it's ISO on the Deere side.
If display/implement firmware can be updated, this issue might be resolved.
As CASE said, 25 Feb 2013: The Case IH ISOBUS Task Controller is software on the display that connects to compatible task controller software on an implement’s electronic control unit (ECU).
https://media.cnh.com/emea/case-ih/case-ih-isobus-task-controller-of...
FWIW: Ag Leader: Supported ISOBUS ECU (TESTED)
Nov 27, 2019 Knowledge
Scroll down to bottom of page, and download, OLDER Tested ISO ECU
https://portal.agleader.com/community/s/article/2047?language=en_US |
ISO question
