Posted 3/13/2026 22:35 (#11584040) Subject: JD Autopath Rows with Raven RCM or Sentinel Controller
Is there anyway to setup Autopath rows on an ISO full width or half width setup without adding a secondary operation. The issue I run into is when you add the 2nd operation the work trigger has to be set off a lift switch or hydraulic.
Is there anyway way to trick an ISO controller like a Raven RCM or Sentinel to allow you to set the Deere display as #rows/row width so the work trigger is always off coverage from the controller. Thanks
JD Autopath Rows with Raven RCM or Sentinel Controller
