|
WCIL | I put on my anhydrous in February with a 40 foot applicator with implement guidance. I had it setup as 16 rows at 30" spacing. On all fields I went around them 3 times to give me 120' to match up with two planter passes with our 24 row 30" planter. I used autopath boundaries for putting on anhydrous and all of my fields have a continous headland of 120'. When planting I make two passes around the field so the 120' sprayer will always be following two identical planter passes and not be running over guess rows on the first pass around.
So now I've got into ops center and generated autopath lines for the planter and on some sides of the field it will make two passes like it should but on some sides it gives me 3 passes that aren't evenly spaced and are overlapping to cover the 3 passes that the 40' application made around the field. What have I messed up to make it do this or is this a problem on Deere's end? Everything seemed to work fine last year when doing this so I'm not sure what I've done differently to cause this now. I'll attach a picture where it shows it making 2 passes on my regular end rows but making 3 on the side of the field.
I do have it set to optimize for fewest paths. Switch to follow source operation path doesn't fix it.
Edited by sserven 3/13/2026 16:59
 (field corner (full).jpg)
Attachments
----------------
 field corner (full).jpg (108KB - 11 downloads)
| |
|
autopath rows
