|
far south central iowa | Put a new center belt on this weekend and now having an issue when starting up that if it’s not going fast enough where the metal divider gets to this lip, it’ll quit turning and I’ll have to reverse it back to get enough momentum for it to go. Once it goes it runs fine? Should I just loosen the belt a bunch to get enough clearance? My old belt was tightened all the way out and didn’t have this issue
 (IMG_6024 (full).jpeg)
Attachments
----------------
 IMG_6024 (full).jpeg (138KB - 2 downloads)
| |
|
Case ih 2062 Draper center belt issue
