|
Statesville, NC | I have a Farm Chem Batch Mate 2.0 I've been using with a Banjo pump pulling from tanks on a trailer. I am now setting it up in the corner of a machine shed. I have municipal water with a 1" meter and line, will only be 75' from the meter. There is 110 psi on the line at this location. The volume should be enough to run the venturi inductor, but I'm wondering if the fittings and valves will handle 110 psi? It has 2" full port Banjo fittings with the rubber ring. I could put a regulator in, but don't want to slow the flow too much.
Edit: The water supplier is not going to want this connected directly to the supply, so I'm probably better off filling a tote and drawing off that with the pump.
Edited by Trent2520 3/27/2025 20:41
| |
|
Maximum water pressure on sprayer inductor and Banjo fittings?
