|
SW Nebraska | I can't figure out why my target population and seeds per acre at the top of my run page show the correct population, but in the bottom right average seeds per acre is lower. My black bars never vary too far up or down and I never see orange or red. See attached picture. Any ideas? I would think if my singulation was that poor I would see orange or red bars down to indicate skips but it gives me nothing.
Edited by CornHusker23 5/7/2024 16:46
 (PXL_20240507_195435108 (full).jpg)
Attachments
----------------
 PXL_20240507_195435108 (full).jpg (92KB - 61 downloads)
| |
|
Gen 4 Planter Monitor Question
