|
northwest ohio | 1-You need to figure out if you are operating on a 4.5 or2.5 can system... The 2630 is 2.5, and if your 4.5 you will need a new circuit board in the moisture meter, and new cab terminators.
2-To actually map yield you would need a GPS signal to know where your at, therefore you would need to put a reciever on your machine, to do so you would need a harness that would go from the reciever to the moisture meter
3- The harness in the cab may need a adapter, sometime they tuck the second connector under the headliner, depending on the year of the machine you might need a whole new cab harness also
Good luck!, it can be done | |
|
JD 9500 using 2630 monitor
