Near Intersection of I-35 & I-90 Southern Mn. | I agree that Pin 2 of Port A is the radar out signal. As stated just using a single wire from Pin 2 to the device will work with many devices. If a ground is also needed that is available on Pin 10 of Port A.
I notice the owners manual suggests needing a pulse amplifier. I have not found this necessary when getting speed to a Raven 450.
Also remember that you will need to access the 750's menu system under the digital out section to setup the radar out behavior.
Edited by tedbear 4/13/2013 12:57
|
trimble 750 pin out
