|
se montana | The last time I asked this question, I was instructed to remove a pressed in sqare plate on the the back of the pump, and then adjust a screw that has a 10 mm locker from there.
A quick glance at my pump last night, mine has a" bolted in" plate. It also has an external stud, with a locking nut. About a 15mm locker. What does this stud adjust (the one accessible from the outside)?
Once I find the right screw, do I turn it counterclockwise?
I know it's 3/4 a turn.
by the way, its a 1994 model
Edited by jfqc 3/9/2012 08:49
| |
|