|
Northeast Nebraska | Looked at my manual today..... Deere obviously is dumber than hell.
In the manual it clearly states
pin 29 "pressure sensor ground"
Pin 30 "pressure sensor #1 5vdc"
Pin 31 "pressure sensor #1 signal"
In the manual, it is only showing one way to calibrate the pressure sensor. You are suppose to install a gauge at the sensor, it turns flow on, then you enter in the pressure that the gauge is reading.
I went to calibrate my sensor today and I had 2 options. One was like mentioned above, and the other was to enter in how many mv/psi. On this page I believe it said something about a 12 volt sensor. My sensor did not work today. My rate controller quit working as well. Got it to the field today and the section valves started acting eratically. Section 1 will turn valve 1 on and valve 2 off. Section 2 is controlling valves 3 and 4. Sections 3 and 4 are doing nothing. I'm getting pissy about the whole situation to say the least. And then mother Deere can't even put it in plain english whether you need a 5 volt or 12 volt sensor. Genius engineers. | |
|