|
Leeds, North Dakota | eddie, i would check and see if input and output shafts are loose, guessing bad brg on input shaft, would drain transmission, see what it looks like, hopefully its just front brg, can remove drive shaft, remove plate and check brg, first see if its loose, there are shims under plate, this is what sets preload on brg, if brg is bad will have to cut it off shaft, when you install brg heat in oven about half hour, we use a small 110 oven, at 400 degrees right by tractor, will slip right on, any questions ask away, good luck, scott. | |
|