I found a shank and hitch for a 7x7 tool bar on Saturday and my welder got it fabricated today. I tried it out and was able to get about 24 inches deep and think I can adjust my hitch so I can get few inches deeper if I need to. I pulled it with our 290 and it wasn't much of a load but it did slip some in a dryland corner.
Edited by golfnut 12/11/2012 18:19
 (Ripper2.jpg)
 (Ripper3.jpg)
 (Ripper1.jpg)
Attachments
----------------
 Ripper2.jpg (61KB - 565 downloads)
Ripper3.jpg (64KB - 536 downloads)
Ripper1.jpg (62KB - 527 downloads)
| 
Single Shank DEEP ripper - NOW WITH PICS!
