Southern Illinois | YES!!! but not with that JD rate controller
If you had the EnvisioPro with a boom sense node and a product control node then it can be set up differently with your switches set to ON to spray that section. The problem is you need the CAN product control to make it all work like that. It can also be used with any CAN Raven controller console the same way such as a 4600. In that case the 4600 is the boom sense and product control node.
Basically
Setup as stand alone or serial connected, all switches must be off as accuboom is wired parrallel to switches
Setup as CAN based all switches must be on, accuboom wired between switches and booms. |