|
Central Nebraska | The inline servo is the valve, not the flowmeter. DICKEY-john flowmeters require at least 10V.
If your flowmeter requires more than 5.5V, you need to make a jumper wire from the 2-pin power connector on that harness and use that to replace the power wire going into the flowmeter connector. Trimble has 12V going to (and through) the harness but derated the voltage going into the flowmeter connector to 5.5V.
Edited by Hope 5/18/2011 15:22
| |
|
Very frustrating 750 display + Field IQ on sprayer
