|
| I need some info on how to calibrate the yield on our Pro 600.
Last fall we did some weight checks in corn and found that the monitor was reading about 5%high.
I had to replace the upper bearings on the clean grain elevator and I moved the shaft up to take out some slack in the chain. After doing this I talked to one of the Case mechanics and he told me that would probably affect the yeild calibration. He moved it back to where he "thought" should be close.
This year we need to have it dead on for insurance . Where should the top shaft be set,how does raising or lowering affect the result?
How do I go into the Pro 600 to calibrate yield. I've tried searching and I've found a little bit about using the wizard. I have not tried to get into it yet.
Thanks | |
|