So. IL | Tomcat - 5/8/2021 18:41
Tried my new to me 500 with Ez Steer.
1) Followed directions in book went to make a test pass and it tells me it can’t engage AB line. But I just set AB.
2) Also short of disconnecting power supply how do I power it down ?
3) At the end of the field what do I need to do to make a turn? Do I need to pull the plunger and tilt it away?
If you reply to my post talk like I know nothing about it.
Start up the display and wait about 10 min to get connected. Then press A, drive at least 160 ft and press B. Steering wheel icon should turn from red to yellow at this point. Press the button next to the steering wheel and it will go green. Get to the end of the row, press the steering wheel button again and it will disengage. Turn around, get lined up and press steering wheel button again. It will turn green. As for shutting display off, push and hold one of the buttons on the left side. I can’t remember which one it is but you push and hold it down for like 10 seconds.
Edited by ekeller2 5/8/2021 19:24
|