|
South Georgia | I really appreciate all of the responses. I did not realize the BaleTrak was using current flow to end the cycle, I assumed that id was using the position reading from the twine position sensor to determine when the twine application cycle was complete. I was never able to find a good theory of operation documented anywhere. I cleaned all of my connections and made sure they were good and tight, after that the baler successfully completed three cycles, so I’m going to call it good for now. If it starts back acting up I’m going to re-power the un-switched side of my 3-prong with my own 8 or 10 AWG wire. Thanks again for the responses! | |
|