|
| Low voltage alarm means it's not getting enough juice. I don't think the auxillary circuit on the 6430 was actually designed for a full 30 amps. Monitor knows the actuator is all the way back when amperage hits 30 amps for 1 second. If the power source can't supply it without dropping below 12.0 volts, you get an alarm.
Fix the voltage supply, either with the kit I mentioned that is expressly for the balers, or by some other means, and all else will go to working.
Note that same would apply for net wrap. | |
|
567 Baler not completing twine wrap cycle successfully
