North central TX | tornapart - 5/5/2021 20:46
Are you plugged into the 3 pin connector in the cab? If so, the wiring feeding it might be too small. We had to add a power kit to some machines to deal with them having the same issue. Basically was 10 ga wiring with a new plug and breakers. You ran to the battery, and into the cab, and it would stop the low voltage alarm.
I'd go with this. Would think the 6430 would be wired heavy enough, but it could be corroded or damaged. Its an easy enough fix just to run a jumper from the positive terminal on the battery or the aux power stud to the monitor and see if it helps. |