|
South Georgia | My 567 baler is not ending its automatic twine wrap successfully. It goes through the process of applying the twine, and cuts the twine, but then it stalls out. The twine actuator never stops actively pressing against the twine knife assembly. The monitor goes into low voltage alarm and the twine actuator stays energized until I hit the “Retract” button on the monitor and back it off the twine knife manually. I suppose the monitor should be doing this automatically? I know it should at least drop out the twine wrap actuator. I have verified the twine wrap sensor calibration per the manual, it is perfect. Any thoughts on what might be going wrong for me? The monitor is a Bale Trak Plus monitor. | |
|