AgTalk Home
AgTalk Home
Search Forums | Classifieds (119) | Skins | Language
You are logged in as a guest. ( logon | register )

Hydrolic cyclinder shaft repair question, can u fix this ?
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
marktheblaster
Posted 5/4/2021 19:07 (#8987511 - in reply to #8986925)
Subject: RE: Hydrolic cyclinder shaft repair question, can u fix this ?


I just completed a repair on my cylinder, using JB weld. Mine were nicks, not worn chrome and pits, so don't know how well it will work for you. I did replace all the seals though. My cylinder is still not leaking, but haven't used it that much. The first step is to file any high spots down. Use progressively finer sand paper, starting with 600 grit, ending with crocus cloth. Use the sandpaper in a shoe shine type movement. Clean really well. Apply JB weld, let cure at least 24 hrs. Replace the seals. File down lightly first, then go through the sandpaper routine again. You should be able to drag a finger nail over it without any catching. Good luck. Do it right, do it once. Seal kit was about $35.00.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)