Posted 5/4/2021 09:42 (#8986741 - in reply to #8986133) Subject: RE: JD 8410 Autotrac not showing up on GS Display
Camp Douglas Wi. 40miles nw of wi. dells
we have had the same issues at times, will start with the most likely solution first
check to see if the 3 prong electrical plug is connected back in the right hand corner of the cab by the cup holder, or maybe it could also be on the power strip in the right front.
Also check the fuse to the outlet.
We have also had a terminator in the harness go bad, but i believe it will throw a code.
This spring we had to jump a tractor with dead batteries and lost the auto steer which threw a code , we cleared the codes and it was ok.
Do you have any electronic devices near the 2630 that may cause interference? unplug them and see what happens.
nothing more frustrating than working 2 days with no auto steer in prime planting conditions only to find out a nearby
display was causing interference.