AgTalk Home
AgTalk Home
Search Forums | Classifieds (132) | Skins | Language
You are logged in as a guest. ( logon | register )

Envizio Pro VR to MicroTrak GSC1000
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Rslohs
Posted 4/20/2021 17:35 (#8963469)
Subject: Envizio Pro VR to MicroTrak GSC1000


SW MI
Have a fertilizer spreader with MicroTrak GSC1000 for rate control. Have been using this for a few years with good luck. In that same time we've been trying to use the Raven Envizio Pro from our combine to feed a VR prescription to the GSC1000, using the GSC1000 as the rate controller still. Have the Variable Rate unlock for Envizio Pro, and the null serial cable that Raven calls for in the Envizio manual to communicate with a serial controller like a Raven 440 or 450. When we go to start the job in the Envizio Pro it will not allow us to select a prescription. There are prescriptions on the Envizio Pro. Raven support says it is because the Envizio Pro is not reading that there is data coming from the controller, but MicroTrak is saying that the GSC has the Raven protocol and should be acting properly. Does the tractor have to be within the field that the prescription is for in order for it to open the prescription selection screen? Has anyone ran into a similar situation?
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)