Posted 4/8/2021 15:11 (#8940158) Subject: Ag Leader Clutch Control Module issues
Hope someone on here can shed some light on my problem. Decided to take the Insight Monitor from my combine and use it with an STMM for planting and tracking different varieties. Came across a used clutch control module and wanted to use it to run my half width shut offs.
The problem I’m running into is the sections are greyed out on the run screen. I have flashing green lights on my modules and CAN switch box. The CCM configured correctly and gave me the 1-2. Could hear the clutches engage when configuring the clutches. (Right now it’s just relays in the cab. Didn’t want to mess with my original wiring till I knew this works.)
When I flip the master switch off on the run screen little box in lower right hand corner goes from Green to red. Switches 1 and 2 do nothing at this point.
From the diagnostic screen the clutch shows all of its outputs as “Not Coneccted”
Diagnostic screen for the switch box all switches change from green on to black off. Not sure which screen it was but f2 is assigned to the left half and f3 is assigned to the right half.
All I found online from Ag Leader was to check my implement switch. Right now I don’t have one hooked up but have the loop installed on the CCM and the STMM.
I have attached some pictures below. It’s just like my CCM isnt talking to the switch box or something. Please help if you can.