Finally bought a local jd 750 drill. Got it for a decent price but it’ll need some work. For sure probably going to replace all the metering boots and fluted tubes. What else should I look at and check over while I’m at it? Some have recommended aftermarket for parts, such as Shoup. Where have you had good luck with parts? Would like to have a 2 point hitch, thought about just having local welder fab up an adapter to bolt into the hitch. Would like to put a scale system on but not sure if I’ll get that far. Any thing else a guy needs to know about these rigs? Plan to do the work myself. Thanks for any input.