|
| TTerry the signal from the steering angle sensor goes to the steering valve on connector x237 pin 1. The reason I asked about it following the line was because I had one that would work sometimes and then be off the line about 2 feet but would still follow the line and that one I ended up replace the sasa sensor which is the sensor on the steering valve to detect steering wheel movement. Still Cannot figure out why it acted like that. And for the c1000 display issue what I would do is have the latest software in and see what happens I’ve had to replace them already for that issue. Here’s a reset procedure you can see if this helps
Attachments ---------------- C1000 reset.pdf (481KB - 216 downloads)
| |
|