|
Texas | If I was close I’d fix your washing machine free of charge. I keep spare parts for Maytag Neptunes. Sounds like the problem could also be pressure switch.
It’s common to need to replace the inner/outer tub bearings and seals. Once the seal fails it doesn’t take long for the inner bearing to go and then the water migrates into the outer bearing.
After cleaning the bearing and seal seating areas thoroughly, I always put silicone of some type on the back side of the seal to further prevent water from getting past. If the seal gets damaged or twisted during installation, the bearings will go bad in a short time.
Edited by Pigpiggy 1/3/2021 18:40
 (407C88BE-8CF3-40C2-A025-BB8FD042D467 (full).png)
Attachments
----------------
 407C88BE-8CF3-40C2-A025-BB8FD042D467 (full).png (146KB - 112 downloads)
| |
|
Suggestions for new washing machine
