|
NE Indiana | I’m not aware of a good guide for ag remote but you’ll need to go into the configuration menu within Ag Remote and set port D to RTCM for incoming data at the correct baud rate to match your parani. One important thing to note is you cannot input correction data and output NMEA on the same port so you’ll need to make a split cable if you are wanting to see the GPS status on the Lefebure NTRIP app. I initially ran into issues with my port settings in Ag Remote not saving or changing on me and I believe it was due to the GPS settings on the FMX (not within ag remote) were set to output NMEA on the same port I was trying to input corrections. I ended up turning the NMEA output completely off until I was able to get the incoming data setup and working. | |
|