AgTalk is committed to operating without commercial advertising. Our fall donation drive is now open.

AgTalk Home
AgTalk Home
Search Forums | Classifieds (62) | Skins | Language
You are logged in as a guest. ( logon | register )

Bypassing dryer - Looking for ideas to dump into an air system
View previous thread :: View next thread
   Forums List -> Crop TalkMessage format
 
tj_farms
Posted 10/15/2020 21:59 (#8547980 - in reply to #8547818)
Subject: RE: Bypassing dryer - Looking for ideas to dump into an air system



Delaware, Ohio
Brahamfireman - 10/15/2020 20:41

Small 4" auger from bottom of wet bin to top of air lock.


Same here except 6" auger about 16' long set in hopper under wet bin, over into the airlock, I regulated corn flow with the wet bin slide gate. need to slow auger down some, but was cheap. Wired it into the air system so would shut off if air system quit. This was a temporary set up for a couple years of dry corn harvest times. I did move the air lock over 4' for access to the wet bin, but I'm sure it be reached to a permanent air lock with a short down pipe on the auger. I ran the air system on manual by filling wet bin a while then start up system and let run while unloading trucks all day. Worked good.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)