AgTalk is committed to operating without commercial advertising. Our fall donation drive is now open.

AgTalk Home
AgTalk Home
Search Forums | Classifieds (6) | Skins | Language
You are logged in as a guest. ( logon | register )

Controlling RowCommand with FieldIQ
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
Posted 10/16/2020 18:19 (#8549139 - in reply to #8547660)
Subject: RE: Controlling RowCommand with FieldIQ

I did a little more searching since no one else has replied and found some listings on Northern TI website for field iq and row command. I will a link for one of those pages below. From what I could find on the row command at least some of them are a 12 volt signal. Agleader make and adapter go from their clutch harness to row command. There should a similar field iq setup.
Top of the page Bottom of the page

Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)